Connector Pinouts

This page lists a few common connector pinouts for different commercial vendors.

Contents

• General Info
• Gamo2 / arcin
  • Phoenixwan+ and Faucetwo
    • Button Pins
    • Encoder Pins
      • 4 Pin
      • 3 Pin
    • RGB
      • ARGB
      • RGB
    • USB and Power
    • Analog
  • Older Controllers
    • Button Pins
    • Encoder Pins
      • IIDX (FPS / FP7 from 2014 on) / arcin (v1.1.1)
• Yuancon / Roxy
  • Button Pins
  • Encoder Pins
  • RGB Pins

General Info

For the purposes of this page:

• Button pins will be marked as Switch or LED.
  • Switch pins should go to the microswitch on the NO and COM terminals. Order does not matter.
  • LED pins should go to the light terminals. If the button does not light, unplug the LED and plug it in the opposite direction.
• Encoder pins will be marked as Data.
  • If the knob / turntable spins the opposite direction as intended and software reversing is not possible, swap the Data pins.
• All connectors are JST XH, unless otherwise noted.

Gamo2 / arcin

Phoenixwan+ and Faucetwo

Button Pins

Encoder Pins

Both 3 pin and 4 pin encoders are supported.

4 Pin

3 Pin

RGB

Both ARGB (WS2812b) and standard RGB (common-anode) have headers.

ARGB

RGB

USB and Power

Analog

Older Controllers

Button Pins

Encoder Pins

Gamo2 has several types of boards. Ensure you are referencing the correct image.

IIDX (FPS / FP7 from 2014 on) / arcin (v1.1.1)

Analog mode is only possible with an arcin board.

Yuancon / Roxy

Button Pins

Encoder Pins

• Analog mode is only possible with a Roxy board.
• Yuancon only supplies 5V. Roxy supplies 3.3V by default, with an optional solder jumper for 5V.

RGB Pins

These RGB ports only support common-anode LEDs.